Article List

• The difference between fasteners and connectors

  Fastener: A fastener is a general term for a class of mechanical parts used to fasten two or more parts (or components) together into a single unit.Connector: Connector is used for steel member, wood member and steel, wood two kinds of connection between the metal parts.What's the difference between

  April 03, 2023
• The general use of U-bolt places are what

  A U-bolt is a U-shaped fastener bolt used to secure pipes to various surfaces and supporting structures.U-bolt is often used in the following construction: metallurgy, petroleum, chemical industry, vehicles, ships, electric power, Bridges and other mechanical hydraulic system of oil, water, gas as t

  March 27, 2023
• The 3rd China (Indonesia) Trade Fair was held in Jakarta

  Participants learn about products at the 3rd China (Indonesia) Trade Fair at the Jakarta International Convention and Exhibition Center in Jakarta, Indonesia, March 16, 2019.The third China (Indonesia) Trade Fair, which lasted for three days, opened in Jakarta on Monday, attracting 725 exhibitors fr

  March 22, 2023
• Inspection procedure of fasteners and screws

  Fastener screws need to be inspected before or after production before they can be put into use. Therefore, in order to get a better use effect of fastener screws, these inspections must be carefully carried out. Hebei Wanchen Fastener Manufacturing Co., LTD. Xiaobian according to the summary of exp

  March 13, 2023
• What problems should we pay attention to in the process of using stainless steel non-standard parts screws?

  I. Fixing of stainless steel screwsIn short, this means that stainless steel screws can be applied to the raw materials of the product, which will make the stainless steel screws not easy to fall. Screws must be securely connected to the raw material of the product. There are always two solutions fo

  March 20, 2023
• Screw skillfully

  1. First, remove the sludge on the surface of broken screws and broken ends and bludgeon the center of the section to death. Then, install a 6-8mm diameter drill bit with an electric drill to drill the center bludgeon hole. After the hole is drilled, remove the small bit and replace it with a 16 mm

  March 06, 2023
• Two types of sealing for fasteners

  1Kazari sealKazari seal: This is a forced seal, with external thread Kazari seal, internal thread Kazari seal and improved Kazari seal in three forms. The external thread kazari seal is the most used. Its gasket is a soft metal gasket with a triangular cross-section, made of copper or aluminum. The

  February 27, 2023
• Common classification of fine self-locking nuts

  The self-locking nut is to avoid the phenomenon that ordinary nuts become loose due to vibration and other reasons during operation. Self-locking nuts are mainly used for loosening and anti-vibration. Used in special places. The task principle is usually self-locking by friction. Self-locking nuts a

  February 20, 2023
• Prevent loose - double nut fastening method

  In daily life, when we are loading screws and nuts, the nut loose phenomenon is often a thing, and we sometimes see a lot of bolts will be used with two nuts, so whether it can prevent the bolt loose? Yes, the following China Standard parts network will provide the prevention of loose - double nut f

  February 13, 2023
• What inspection should fastener screws go through?

  Fastener screws need to be inspected before or after production before they can be formally put into use. Therefore, in order to get better use effect of fastener screws, we must be careful and careful when carrying out these inspections. According to the summary experience, China Standard Parts Net

  February 06, 2023